The dust shroud works great and was easy to assemble

Jacob
Had a serious issue with Triton 3.25 router. Returned it. Now I need advice on where to go in terms of replacement
Joe

Your table is awesome. My problem is learning how to set my new plunge router and dust on narrow boards. But the table is awesome 👌.
I've been cutting walnut lumber 1.25 thick 8 to 16 in. Wide it does a good job

Little bit of work on assembly and install a complete vacuum piping for it but well worth it. Had done a piece without and did a similar piece with it and was practically nothing to sweep up. Definitely worth it.

Having had the gantry system for a while I've enjoyed how great it works. The one issue was the amount of dust all over the place, including back in my face. Adding the dust collection shroud seemed a no brainer. It does keep the dust down in the shop and it stops the dust from coming back in my face. However, I mostly work with thinner pieces of material (1 or 2 feet wide by up to 8 feet long) the shroud itself has a wide footprint, most of the time one end or the other is not over the material and most of the larger dust shoots out any opening left available. Overall, the recovery of material is low, probably under 20%, but it does keep the smaller particles from traveling all over the shop and deflects most material down and away. Also as mentioned by others, you lose a few inches of travel on either end.